Just looked at the Okuma App Store and saw a few interesting apps. One in particular is the part flip monitor.
https://www.myokuma.com/part-flip-monitor
Anyone using it, or any other apps?
I run a lot of parts in my Genos L300M that get flipped. Looks like it could save a part here an there if an operator is not paying attention.
https://www.myokuma.com/part-flip-monitor
Anyone using it, or any other apps?
I run a lot of parts in my Genos L300M that get flipped. Looks like it could save a part here an there if an operator is not paying attention.