I am not going to post the part here, email me for a print if you can EDM wire or sinker something with a 25" long feature akin to drilling or broaching Also, a shaper could work too, something with a 13"+ travel might work the part could be flipped. IT does not need to be accurate.
The tolerances on the part are wide open +/- 0.020
The surface finish can be garbage, i don't care
I just need material removed
rsheets at odinhi dot com
The tolerances on the part are wide open +/- 0.020
The surface finish can be garbage, i don't care
I just need material removed
rsheets at odinhi dot com
Last edited: