bob11x
Aluminum
- Joined
- Jan 11, 2010
- Location
- Rochester, NY
I have recently acquired a very nice model 14F-3A drill press with a lot of bells and whistles.
It has the table adjustment "pump", multi-speed pulley attachment, and 2 accessory tool trays.
It is fairly quiet but I have new bearings ordered.
I need to take it apart anyway as the spindle shaft is not retained in the column properly. The spindle shaft with chuck floats up and down inside the quill.
I am unable to find any parts breakdowns for this unit (or YouTube videos). All seem to show the spindle pulley stub assy bearings being retained with 2 set screws in from the left and right side. This one has the bosses cast in but no drilled and tapped holes. There is one setscrew in from the front on the same plane. It wasn't tight when I bought it but I suppose it is the retainer?
I need to take it apart anyway as the spindle shaft is not retained in the column properly. The spindle shaft with chuck floats up and down inside the quill.
Anyone have PDF's for the 3A series? Any idea of the year?
Thank you.
Bob
It has the table adjustment "pump", multi-speed pulley attachment, and 2 accessory tool trays.
It is fairly quiet but I have new bearings ordered.
I need to take it apart anyway as the spindle shaft is not retained in the column properly. The spindle shaft with chuck floats up and down inside the quill.
I am unable to find any parts breakdowns for this unit (or YouTube videos). All seem to show the spindle pulley stub assy bearings being retained with 2 set screws in from the left and right side. This one has the bosses cast in but no drilled and tapped holes. There is one setscrew in from the front on the same plane. It wasn't tight when I bought it but I suppose it is the retainer?
I need to take it apart anyway as the spindle shaft is not retained in the column properly. The spindle shaft with chuck floats up and down inside the quill.
Anyone have PDF's for the 3A series? Any idea of the year?
Thank you.
Bob