Hi all. My SB 9 has a 3-jaw chuck which is stuck on there real good. I know it hasn't been off in at least 25 years, probably considerably longer.
I found a thread with a lot of useful tips for unsticking one, including make a wrench to grab the back end of the spindle.
Before I set about making one, possibly dumb question: My spindle has a hole, about 1/4", bored through the smooth end of the spindle, just outside the gear. Is there any reason I couldn't use a spanner-type wrench in there?
I'm trying to avoid doing something stupid and then having to post about it
Thanks in advance . . .
I found a thread with a lot of useful tips for unsticking one, including make a wrench to grab the back end of the spindle.
Before I set about making one, possibly dumb question: My spindle has a hole, about 1/4", bored through the smooth end of the spindle, just outside the gear. Is there any reason I couldn't use a spanner-type wrench in there?
I'm trying to avoid doing something stupid and then having to post about it
Thanks in advance . . .