Chris Sandberg
Aluminum
- Joined
- Mar 18, 2008
- Location
- Portland, Oregon
Hello Group,
I am getting close to finishing my SB9"A rebuild but still have a question. I have a 5.1/2" three jaw and 7.1/2" four jaw Union MFG Co. chucks that I need to disassemble, clean and lubricate. I was wondering what I should be using when I reassemble them. Is an oil all that is needed or will a grease of some type be better. please advise a newbie/beginner what to use and any other things to watch out for or that need to be done. Are these chucks good and what if any issues do they have.
Thanks in advance.
Chris a newbie/beginner
I am getting close to finishing my SB9"A rebuild but still have a question. I have a 5.1/2" three jaw and 7.1/2" four jaw Union MFG Co. chucks that I need to disassemble, clean and lubricate. I was wondering what I should be using when I reassemble them. Is an oil all that is needed or will a grease of some type be better. please advise a newbie/beginner what to use and any other things to watch out for or that need to be done. Are these chucks good and what if any issues do they have.
Thanks in advance.
Chris a newbie/beginner
Last edited: