Is a counter shaft *MASS* pulley needed with VFD setup - Page 2
Close
Login to Your Account
Likes Likes:  0
Page 2 of 2 FirstFirst 12
Results 21 to 27 of 27
  1. #21
    Join Date
    Jul 2010
    Location
    Virginia, USA
    Posts
    3,461
    Post Thanks / Like
    Likes (Given)
    87
    Likes (Received)
    638

    Default

    Do not swap any parts, you will just screw something up. Swapping the spindle cone pulley for a generic pulley will prevent your back gear from working, for instance.

    Given the small diameter of the motor pulley, I would use 6 rib, assuming I could find a small pulley that wide.

    allan

  2. #22
    Join Date
    Jul 2004
    Location
    Houston, TX USA
    Posts
    30,039
    Post Thanks / Like

    Default

    Quote Originally Posted by sandman-pi View Post
    Like click on picture link icon - go grap photo and insert image.. I know there must reasons for not having..

    .

    Handy recent post right in the SB section

    Posting Pictures on the South Bend Forum

  3. #23
    Join Date
    Jan 2020
    Country
    UNITED STATES
    State/Province
    Texas
    Posts
    15
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default

    thx.. Using cellphone \ long story short had to force my cell to load full site / info... The advanced reply to thread info / options where not being displayed to me .

    Basic mode / view / of forum via cellphone does not let you do much more then reply or post text.. Its been so long I forgot about clicking on full site info etc.. ��
    Last edited by sandman-pi; 01-20-2020 at 11:16 PM.

  4. #24
    Join Date
    Jan 2020
    Country
    UNITED STATES
    State/Province
    Texas
    Posts
    15
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default

    spindle-bottom.jpgspindle-bac.jpgspindle.jpgrailmarks-1.jpglot.jpg

  5. #25
    Join Date
    Jan 2020
    Country
    UNITED STATES
    State/Province
    Texas
    Posts
    15
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default

    A few more.. More coming.
    Attached Thumbnails Attached Thumbnails thread-gears2-1.jpg   thread-gears.jpg   spindle-bac.jpg   spindle-pulley.jpg   spindlep2.jpg  


  6. #26
    Join Date
    Jan 2020
    Country
    UNITED STATES
    State/Province
    Texas
    Posts
    15
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default

    lathe-tag.jpggears.jpgframe.jpgspindlet.jpg3jaw.jpg

  7. #27
    Join Date
    Jan 2020
    Country
    UNITED STATES
    State/Province
    Texas
    Posts
    15
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default

    tailstock.jpgbed.jpgthread-unit.jpglathe-lot.jpg


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •