I figured I would run this by the forum before re-purposing this piece.
I have a lathe faceplate which is approximately 15 3/16" in diameter and 2 3/8" thick with 2 3/8-6 threads.
I was under the impression that it would fit a South Bend 16 or 16-24. This has been thrown into doubt by a forum member who believes it will not clear the feet on the headstock casting (thanks for the heads-up Tom).
Thing is, the large faceplate SB offered for the 16-24 is 22 3/4" dia., so why doesn't it rub?
Does anyone have a 16-24 with the large faceplate, who can offer some insight?
Does anyone know of another lathe which has a 2 3/8-6 spindle which this would fit?
I'm just trying to figure out what I have, and if anyone can use it, before I turn it into a base for a grinder pedestal.
I have a lathe faceplate which is approximately 15 3/16" in diameter and 2 3/8" thick with 2 3/8-6 threads.
I was under the impression that it would fit a South Bend 16 or 16-24. This has been thrown into doubt by a forum member who believes it will not clear the feet on the headstock casting (thanks for the heads-up Tom).
Thing is, the large faceplate SB offered for the 16-24 is 22 3/4" dia., so why doesn't it rub?
Does anyone have a 16-24 with the large faceplate, who can offer some insight?
Does anyone know of another lathe which has a 2 3/8-6 spindle which this would fit?
I'm just trying to figure out what I have, and if anyone can use it, before I turn it into a base for a grinder pedestal.