FS - 9/10k Milling Attachment (Needs Work)

JLeather · Nov 7, 2018

Picked this up in a box lot. I believe the original mount must have been damaged, or else someone thought they'd adapt it to another lathe. Either way the spud on the bottom has been machined off. Someone made a replacement, not sure if it's the right size for a SB or not. The rest of the piece is undamaged, even includes the handle. Needs cleaning up and the mount remade/attached. Price reflects the condition at $150 plus shipping (should fit in a flat rate box).

Sent from my XT1585 using Tapatalk

Krazz · Nov 7, 2018

PM inbound

JLeather · Nov 9, 2018

SOLD...Thanks for looking

k3vyl · Nov 14, 2018

The two holes on the radius of the flange would indicate that it was used on some other machine. Maybe an earlier south bend. That piece is ready for it to go back on a later SBL by the look of it.
I made one of those things for my 13”machine but haven’t had a use for it yet. Was thinking angle plate. Might use it to anchor the Palmgren milling vise. Milling on a lathe is not as easy as it looks but can be done. The secret is holding the cutter in a setscrew type holder not a chuck or even a collet.

Search

Largest Manufacturing Technology Community on the Web

Search

FS - 9/10k Milling Attachment (Needs Work)

JLeather

Cast Iron

Krazz

Plastic

JLeather

Cast Iron

k3vyl

Stainless

Similar threads