mattthemuppet
Stainless
- Joined
- Apr 22, 2016
- Location
- San Antonio
I've managed to find a place in the garage where I'm not tripping over it every time I go in there, but I'd still like to find a new home for it and ideally something more useful to me
this casting came with my 1929 wide 9 (reassembly thread down there somewhere). It's in good condition, probably been repainted at some point, the bed clamps are there, the tensioner swivel moves freely as do the adjustable stops and the main pivot bearings look ok (a little scored, probably from a burr on the shaft on removal).
Doesn't come with anything else, no motor mount plate or countershaft. If it did, I'd be using it myself.
I'd prefer to trade it for something - things that come to mind are a 6 jaw chuck (well, I can ask, right?), a follow rest (even more hopeful), 2 axis DRO or a rotary table or dividing head for the mill (6" would be a good fit). Also open to ideas.
Can trade for cash too, which I can then spend on one of the above
this casting came with my 1929 wide 9 (reassembly thread down there somewhere). It's in good condition, probably been repainted at some point, the bed clamps are there, the tensioner swivel moves freely as do the adjustable stops and the main pivot bearings look ok (a little scored, probably from a burr on the shaft on removal).
Doesn't come with anything else, no motor mount plate or countershaft. If it did, I'd be using it myself.
I'd prefer to trade it for something - things that come to mind are a 6 jaw chuck (well, I can ask, right?), a follow rest (even more hopeful), 2 axis DRO or a rotary table or dividing head for the mill (6" would be a good fit). Also open to ideas.
Can trade for cash too, which I can then spend on one of the above