Vladymere gr
Hot Rolled
- Joined
- Dec 10, 2008
- Location
- Charlotte, NC
Hello all,
Can anyone provide me with the factory under drive mounting hole and head stock and tail stock mounting hole locations as well as the tray opening location under the head stock?
Perhaps someone is in the midst of a refurbishment and can make these measurements for me, if they would be kind enough?
I ask because my mounting holes appear to have been made by an oxyacetylene torch and located by trial and error. I don't know it this under mount was purchased for this lathe or not. I say this as my factory build cards show that this heavy 10 was ordered in late 1942 by the Marietta Airplane Assembly Plant without a bench so who knows where this bench was acquired.
Thank you,
Vladymere
Can anyone provide me with the factory under drive mounting hole and head stock and tail stock mounting hole locations as well as the tray opening location under the head stock?
Perhaps someone is in the midst of a refurbishment and can make these measurements for me, if they would be kind enough?
I ask because my mounting holes appear to have been made by an oxyacetylene torch and located by trial and error. I don't know it this under mount was purchased for this lathe or not. I say this as my factory build cards show that this heavy 10 was ordered in late 1942 by the Marietta Airplane Assembly Plant without a bench so who knows where this bench was acquired.
Thank you,
Vladymere