Just purchased my first lathe. I am not a machinist. But i know a few to help me out. I found a serial number, lathe looks to of had a coat of paint on it so i tried looking for the cast number i seen in a video. The face of the head stock chuck to the chuck face in tail stock is 5 feet. The center of chuck to the top of rail is about 7.50 inches. Its a 1/2hp 110v. I want to restore it and get it dialed in. Also need a half nut. There was only 1 on the screw that i found stuck to it and not in the holder. Any help would be appreciated thanks.. have pictures just trying to figure out how to load them. Rookie.