1-1/2 hp, currently wired for 220v- but would need to run new power to it's location.
Electrical, is not my strong suit...
The motor plate indicates it can be wired for 110v, but because the wiring is run through the lathe's breaker/drum switch the schematic on the plate is even more useless to me
Is it possible- and does it make sense- to change the wiring to 120v so I can use existing outlets, or should I leave it as 220v and run a new circuit?
Electrical, is not my strong suit...
The motor plate indicates it can be wired for 110v, but because the wiring is run through the lathe's breaker/drum switch the schematic on the plate is even more useless to me
Is it possible- and does it make sense- to change the wiring to 120v so I can use existing outlets, or should I leave it as 220v and run a new circuit?