so i was digging in the mound of stuff looking for a 10L spindle to change out a 1-7/8 in a 1943 10" its been sitting for 15 years and look what i found the only good thing is the draw bar can be trimmed down for a 10H as who out there has a g-26-t that's looking for a collet set up
yes but for the g-26-t only . the set ups were made by royal the hand wheel shaft is a bit to long for the 10h threaded spindle but can be shorten the c-5 collet adapter is not the same as the 10H i believe it is no.5 mt
so i was digging in the mound of stuff looking for a 10L spindle to change out a 1-7/8 in a 1943 10" its been sitting for 15 years and look what i found the only good thing is the draw bar can be trimmed down for a 10H as who out there has a g-26-t that's looking for a collet set up
I'll bring this back from the dead since its not toooo old and you may still have the pieces.
I just bought a G-26-T, how much do you want for a setup. The pieces that came with mine are a bit dinged up. mostly interested in the spindle adapter as a spare would be a good idea.
This website or its third-party tools process personal data (e.g. browsing data or IP addresses) and use cookies or other identifiers, which are necessary for its functioning and required to achieve the purposes illustrated in the cookie policy. To learn more, please refer to the cookie policy. In case of sale of your personal information, you may opt out by sending us an email via our Contact Us page. To find out more about the categories of personal information collected and the purposes for which such information will be used, please refer to our privacy policy. You accept the use of cookies or other identifiers by closing or dismissing this notice, by scrolling this page, by clicking a link or button or by continuing to browse otherwise.