Tailstock handwheel installation
Close
Login to Your Account
Likes Likes:  0
Results 1 to 3 of 3
  1. #1
    Join Date
    Feb 2015
    Country
    UNITED STATES
    State/Province
    Georgia
    Posts
    1
    Post Thanks / Like
    Likes (Given)
    0
    Likes (Received)
    0

    Default Tailstock handwheel installation

    I have just finished rebuilding a Heavy 10. I can not seem to figure out the proper way to reinstall the handwheel on the tailstock. I have the version with a threaded shaft that uses a small pin between the wheel and shaft. I can not get the pin to drive into the hole between the wheel and shaft. is there a trick?

    Thanks in advance for any assistance.

  2. #2
    Join Date
    Jul 2008
    Location
    South Bend, In
    Posts
    2,575
    Post Thanks / Like
    Likes (Given)
    153
    Likes (Received)
    234

    Default

    The HEAVY 10 has what’s called a “Dutchman Key” (a straight pin use as a key)
    If you are using the same Handwheel and screw, the half-holes should line up. They were machined together. If they aren’t a matched set, you will have to drill a new hole(keyway)
    Ted

  3. #3
    Join Date
    Sep 2010
    Location
    moscow,ohio
    Posts
    5,691
    Post Thanks / Like
    Likes (Given)
    551
    Likes (Received)
    1799

    Default

    I deleted my original reply...my eyes played a trick and Didn't see the heavy 10 part...


Tags for this Thread

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •