Dale Lusby
Cast Iron
- Joined
- May 5, 2008
- Location
- Gold Country, CA
Does the taper attachment from a 9(a,b or c) fit a 10k? Been looking for one for a while and may have one I can buy but making sure it'd fit my machine. Thanks for any advice!!!
Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Largest Manufacturing Technology Community on the Web
Stay Connected:
Will 9" taper attachment fit 10k?
- Thread starter Dale Lusby
- Start date
- Replies 1
- Views 884
If you're referring to the 9N / workshop, the answer is yes. If you are referring to the 9JR, Commonly called heavy 9, The answer would be no.
Assuming your talking about the 9N, There should be 2 bolt holes on the back of your saddle, Along with 2 Holes for Alignment pens. If these are not present you will have to drill and tap them. Also alignment is pretty critical. You'll need to melt out the Babbitt in the bed mounting bracket, and Re-pour It once it is Properly aligned.
Stay safe and have fun.
Joe.
Assuming your talking about the 9N, There should be 2 bolt holes on the back of your saddle, Along with 2 Holes for Alignment pens. If these are not present you will have to drill and tap them. Also alignment is pretty critical. You'll need to melt out the Babbitt in the bed mounting bracket, and Re-pour It once it is Properly aligned.
Stay safe and have fun.
Joe.
