Likes: 0
Results 1 to 3 of 3
Thread: 14.5 SB lathe parts needed
-
10-19-2020, 02:47 PM #1
Plastic
- Join Date
- Nov 2012
- Location
- Selah Washington U. S. of A.
- Posts
- 23
- Post Thanks / Like
-
- Likes (Given)
- 16
- Likes (Received)
- 3
14.5 SB lathe parts needed
I need some parts I can’t find for this 14.5 x 6 SB lathe. I have found some of them, but right now I need several clutch plates for the friction drive.
Those seem to be the hardest to find.
I’m sure as I continue to take this wreck apart I will find more I need.
TIA
BB
-
-
10-20-2020, 09:15 AM #2
Diamond
- Join Date
- Jul 2004
- Location
- Houston, TX USA
- Posts
- 31,706
- Post Thanks / Like
-
If they are FLAT....I need several clutch plates
II made some years ago by getting up a DXF drawing and water jetted some out of 4130N steel sheet of the right thickness for a large Asian lathe
-
10-20-2020, 05:22 PM #3
Plastic
- Join Date
- Nov 2012
- Location
- Selah Washington U. S. of A.
- Posts
- 23
- Post Thanks / Like
-
- Likes (Given)
- 16
- Likes (Received)
- 3
Originally Posted by johnoder
Most of them are fairly flat, one is pretty much trashed and many of them have .003-.004 wear on them.
I’m hoping to find a book or manual or something that gives dimensions of these parts so I can figure out what is actually worn out. I’m thinking most of this lathe is junk, but I can’t say for sure without knowing if the parts are in serviceable spec.
Reply With Quote
Bookmarks