partsproduction
Titanium
- Joined
- Aug 22, 2011
- Location
- Oregon coast
This is our third run of these, and never a complaint. They are made on specifications derived from several old bull gears, the blanks with threaded steel inserts pressed in place, 2 drilled stop pin holes, phenolic grade C thermo-setting composite. The helical gear teeth were cut by a Portland Oregon gear making shop.
The two stop pins included but not installed, drive them in with a small hammer when you assemble the gear in the shaper.
The price is based also on original replacement prices with inflation calculated, $120 delivered where ever USPS flat rate goes.
I hope to include a photo tomorrow. Thanks,
parts
The two stop pins included but not installed, drive them in with a small hammer when you assemble the gear in the shaper.
The price is based also on original replacement prices with inflation calculated, $120 delivered where ever USPS flat rate goes.
I hope to include a photo tomorrow. Thanks,
parts