Matthew Carel
Plastic
- Joined
- May 31, 2019
I recently acquired an Okuma LS lathe which will replace my Colchester 17". The Colchester is basically worn out to the point where the ways would need re-round and saddle built back up. The headstock can be pretty noisy as well, so that was the deciding factor to replace the lathe. There are several good parts on it including two Cushman 12" L02 mount chucks (both which are in very good condition). If there is anything that anyone may need from this machine before I haul it off to the scrapyard, PM or give me a call at 405-623-8019. Thanks.
