Hey folks, I am switching my Bridgeport Series 1 back to R8 and I am freeing up a lot of parts:
-Erickson QC spindle including wrench (will need bearings before you install it). The spindle includes the original Erickson wrench.
-11 matching tool holders
-1 Taper holder with small Jacobs drill chuck
-1 Collet holder with 5 collets
-1 Collet holder with 17 collets, Hertel ER32
This is a nice complete setup for anyone looking to convert to QC system.
I am looking for $1000 plus shipping for everything, prefer to sell as a set and not break it up. Open to reasonable offers. I am located in Los Angeles but I can ship it.
-Erickson QC spindle including wrench (will need bearings before you install it). The spindle includes the original Erickson wrench.
-11 matching tool holders
-1 Taper holder with small Jacobs drill chuck
-1 Collet holder with 5 collets
-1 Collet holder with 17 collets, Hertel ER32
This is a nice complete setup for anyone looking to convert to QC system.
I am looking for $1000 plus shipping for everything, prefer to sell as a set and not break it up. Open to reasonable offers. I am located in Los Angeles but I can ship it.
Last edited:
