leeko
Stainless
- Joined
- Jun 30, 2012
- Location
- Chicago, USA
I have some surplus spools of flux core wire and some EDM graphite blocks/electrodes I'd like to sell. Prefer local pickup in Chicago, but willing to ship if needed. Pictures are located here:
Flux Core spools - Google Photos
- Lincoln NR-203MP innershield 5/64” (2.0mm) 14lb spool - $40 (2x available)
- Lincoln outershield 71M 0.045" partial spool, mild tarnish on upper side of spool - $20
- Lincoln NR-202 5/64” (2.0mm) 14lb spool, some rust - $40 (2x available)
- 5356 Aluminium 3/64" partial spool $35
- unmarked/mystery steel wire (blue partial spool) - $20
And the graphite... Unknown grade, but appears to be quite fine and the machined features show good detail. Came out of an EDM shop, so I'd guess it's a pretty good grade but can't verify.
I have a few pieces, mostly around 8" x 8" x 1" or so. A couple bigger/thicker pieces also. There are some machined features in most of them, mostly just holes but there is also plenty of unmolested graphite
Not sure what the going rate for this would be, so I'll start at around half of what I found on eBay sold listings:
$20 for an 8x8x1 (5lb) chunk?
Let me know if the price is way off, or there's just no demand for this stuff. If there's no interest at that price, I'll likely bring it down every couple of days or so
Or feel free to make an offer for the whole lot - minus a couple of pieces for my electrolysis tank
Thanks
Lee
Sent from my SM-N960U using Tapatalk
Flux Core spools - Google Photos
- Lincoln NR-203MP innershield 5/64” (2.0mm) 14lb spool - $40 (2x available)
- Lincoln outershield 71M 0.045" partial spool, mild tarnish on upper side of spool - $20
- Lincoln NR-202 5/64” (2.0mm) 14lb spool, some rust - $40 (2x available)
- 5356 Aluminium 3/64" partial spool $35
- unmarked/mystery steel wire (blue partial spool) - $20
And the graphite... Unknown grade, but appears to be quite fine and the machined features show good detail. Came out of an EDM shop, so I'd guess it's a pretty good grade but can't verify.
I have a few pieces, mostly around 8" x 8" x 1" or so. A couple bigger/thicker pieces also. There are some machined features in most of them, mostly just holes but there is also plenty of unmolested graphite
Not sure what the going rate for this would be, so I'll start at around half of what I found on eBay sold listings:
$20 for an 8x8x1 (5lb) chunk?
Let me know if the price is way off, or there's just no demand for this stuff. If there's no interest at that price, I'll likely bring it down every couple of days or so
Or feel free to make an offer for the whole lot - minus a couple of pieces for my electrolysis tank
Thanks
Lee
Sent from my SM-N960U using Tapatalk