Hi:
I have some Miltronics Partner IV mill parts to give away. Scrapped the mill.
4 DC servo motors - manual says they are Fanuc 5M or equivalent
X, Y, Z Servo cards
Video Card
RS-232 control box
All I can tell you is the monitor light up and had characters, otherwise did not run. Everything was supposed to work but the mother board had an issue (seller's story). That's all I know.
You pay boxing and shipping costs
NOTE: I will scrap out the listed parts on or about August 16, 2019 if no one wants them.
George
[email protected]
I have some Miltronics Partner IV mill parts to give away. Scrapped the mill.
4 DC servo motors - manual says they are Fanuc 5M or equivalent
X, Y, Z Servo cards
Video Card
RS-232 control box
All I can tell you is the monitor light up and had characters, otherwise did not run. Everything was supposed to work but the mother board had an issue (seller's story). That's all I know.
You pay boxing and shipping costs
NOTE: I will scrap out the listed parts on or about August 16, 2019 if no one wants them.
George
[email protected]
