mjk
Titanium
- Joined
- Oct 20, 2005
- Location
- Wilmington DE USA
I have a set of (4) used but in VGC Airloc PRG170/705 Jacmounts
I had planned on using them on a mill, then the mlll didn't need them, saved them for the air compressor.
It was easier to repack the original air compressor pads than modify the mounts to fit these.
Tech sheet lists 9000 lb max load (each)
Pad diam 170mm
16mm stud diam
I have the pdf spec sheet or Airloc site has the same
Pic is of just 1, I do have all 4 that are in similar condition
If no one needs them, up on the shelf, maybe give me an excuse to buy something big enough to need them.
$120 shipped wherever flat rate Priority Mail goes, Paypal or check
post interest in case there's a stampede.....
pm for more details or payment info
I had planned on using them on a mill, then the mlll didn't need them, saved them for the air compressor.
It was easier to repack the original air compressor pads than modify the mounts to fit these.
Tech sheet lists 9000 lb max load (each)
Pad diam 170mm
16mm stud diam
I have the pdf spec sheet or Airloc site has the same
Pic is of just 1, I do have all 4 that are in similar condition
If no one needs them, up on the shelf, maybe give me an excuse to buy something big enough to need them.
$120 shipped wherever flat rate Priority Mail goes, Paypal or check
post interest in case there's a stampede.....
pm for more details or payment info