FS: Ames 1AM collets and drawbar

Jim S. · Feb 20, 2020

2 Ames collets, 5/8" and 1" round. Style unmarked but measure as 1AM. Usable condition but show signs of minor rust pitting and wear. Bores are very smooth. 1" was bored by PO in threaded area leaving threads very thin.
Drawbar has no makers mark but appears very well made. Threads very good condition. Length of tube below shoulder 5.925".

$25 plus medium USPS flat rate.
Jim

Jim S. · Mar 2, 2020

Free to a good home for cost of postage. I'd simply prefer not to toss in the trash.

jhruska · Mar 3, 2020

I will pay for the ride

pm sent.
John

Jim S. · Mar 3, 2020

Ride sold! Thanks John

jhruska · Mar 7, 2020

The Ride stopped here this Saturday morning.
Thanks, John

ddayan · Jun 11, 2020

Hello,

I have an Ames milling machine that is need of a draw bar. It seems that the thread on the arbor is 24 TPI with an OD of 1.125

The length is roughly 6 inches from the rear to the threads on the arbor.

Any thoughts on finding a draw bar for my mill?

Thanks

jim rozen · Jun 12, 2020

ddayan said:
Hello,
Any thoughts on finding a draw bar for my mill?
Thanks

Given that Dave Sobel's shop no longer exists, your best bet is to manufacture
one on your own. Some tubing, a handle, and the ability to ID thread is all that's
required. Use a thrust bearing.

jhruska · Jun 19, 2020

Packaged up the closer and the collets and sent them on to ddayan in Pa. for cost.

John

Search

Largest Manufacturing Technology Community on the Web

Search

FS: Ames 1AM collets and drawbar

Jim S.

Hot Rolled

Jim S.

Hot Rolled

jhruska

Titanium

Jim S.

Hot Rolled

jhruska

Titanium

ddayan

Plastic

jim rozen

Diamond

jhruska

Titanium

Similar threads