mjk
Titanium
- Joined
- Oct 20, 2005
- Location
- Wilmington DE USA
FS: Erickson Model 401AT Pneumatic lathe chuck
I bought this about 15 years ago advertised as a 5C air chuck.
Its not a 5c although a 5C collet drops into the bore, the threads are different.
Requires splitting as shown to access loading of collet, probably a dedicated fixture piece.
Not sure if it works properly if the correct collet were inserted.
Inside is clean, appears the entire unit may have been vapor degreased.
The mounting flange is approx 8" x 1"
Weight about 28lbs
Doesn't sell I'll remove the mounting flange and use it for something.
If anyone has any info on these that would be appreciated.
I can fit it into a large flat rate
$45.00 shipped
Paypal by friend or USPS mo
please post interest and pm me for details
I bought this about 15 years ago advertised as a 5C air chuck.
Its not a 5c although a 5C collet drops into the bore, the threads are different.
Requires splitting as shown to access loading of collet, probably a dedicated fixture piece.
Not sure if it works properly if the correct collet were inserted.
Inside is clean, appears the entire unit may have been vapor degreased.
The mounting flange is approx 8" x 1"
Weight about 28lbs
Doesn't sell I'll remove the mounting flange and use it for something.
If anyone has any info on these that would be appreciated.
I can fit it into a large flat rate
$45.00 shipped
Paypal by friend or USPS mo
please post interest and pm me for details