rimcanyon
Diamond
- Joined
- Sep 28, 2002
- Location
- Salinas, CA USA
Monarch 10EE 1.25" tailstock ram, complete with screw & nut, dial, etc.
It has typical wear, i.e. the center is smaller in dia. than the ends by .002". However, the good news is that it is an oversize ram, i.e. the diameter at both ends is .0025 over, so that gives some latitude for fitting...
Will fit, or can be fitted to, any Round Dial or Square Dial tailstock, up to the point where the ram diameter was increased to 2" (mid-60's?).
It has some cosmetic damage at the top front, see photo. The little lock screw for the dial is bent & broken, but I am including it so that you can make a copy. $75 plus shipping from Salinas, CA.
It has typical wear, i.e. the center is smaller in dia. than the ends by .002". However, the good news is that it is an oversize ram, i.e. the diameter at both ends is .0025 over, so that gives some latitude for fitting...
Will fit, or can be fitted to, any Round Dial or Square Dial tailstock, up to the point where the ram diameter was increased to 2" (mid-60's?).
It has some cosmetic damage at the top front, see photo. The little lock screw for the dial is bent & broken, but I am including it so that you can make a copy. $75 plus shipping from Salinas, CA.