What's new
What's new

FS Skinner 4 jaw 6" lathe chuck (#906-48) jaws, screws and retainers

mattthemuppet

Stainless
Joined
Apr 22, 2016
Location
San Antonio
Full disclosure - these came off a junk chuck that had a couple of slots busted out. I can't see any consequences in the jaws, screws or retainers though.

Narrow jaw faces are in good condition with no signs of uneven wear, broad jaw faces are more varied, some are chipped or broken. Base of jaws is good for all jaws. Retainers show little wear. Screw threads are good (a little wear evident on one of them that I can see) but the key ends are kinda boogered on all of them. I've done my best to measure all the relevant dimensions. If there are any other pictures or dimensions you would like to see please let me know, I'm happy to help. $80 shipped by USPS Priority small flat rate box.

IMG_9830.jpgIMG_9835.jpgIMG_9836.jpgIMG_9837.jpgIMG_9838.jpg
 
They are not an exact match, but close enough I am willing to take a chance.

Will PM you with my email.

thanks
 
chuck jaws are available again - didn't fit Fal Grunt's chucks. One of his Skinner chucks has "227" on the side of the chuck body, so that's a data point.
 








 
Back
Top