What's new
What's new

FS/Trade Grinder arbor and parts

Rex TX

Titanium
Joined
Sep 20, 2004
Location
Fort Worth, Texas
Unknown grinder arbor and assorted parts
See photos

All are 1.250 OD for 1.25 ID wheels

1 Arbor with nut, 1.25"-16 TPI LH thread
ID taper is 1" at mouth, tapers to .700"

1 arbor no nut, 1.25"-18 tpi RH thread
ID taper is 1" at mouth, tapers to .700" (same as above)

1 nut 2.25' od 1.25-16 TPI

1 nut 2.50' od 1.25-16 TPI

.024" spacer
.122" spacer

$75 shipped for all or trade for complete arbor to fit my Delta-Milwaukee surface grinder



IMG_2371.jpgIMG_2367.jpgIMG_2369.jpgIMG_2370.jpgIMG_2368.jpg
 
I have an arbor that might be for a Delta-Milwaukee. It appear to match the dimensions on the sopko site for a .87 large end and tapers to .535 at the small end. It takes 1.25 wheels and is rh thread. Overall length is 1.32", will fit a half inch thick wheel, also has a .030 spacer. It is to small for my Micromaster
or KO Lee cutter grinder.
 
I have an arbor that might be for a Delta-Milwaukee. It appear to match the dimensions on the sopko site for a .87 large end and tapers to .535 at the small end. It takes 1.25 wheels and is rh thread. Overall length is 1.32", will fit a half inch thick wheel, also has a .030 spacer. It is to small for my Micromaster
or KO Lee cutter grinder.

I am not where I can check that anytime soon.
Did you see a SKU for the Sopko listing that matches yours?

ETA: 00815 looks like the correct one, and your dimensions match. Looks good to me.
I'll pack my arbor lot and wait to hear from you.
 








 
Back
Top