What's new
What's new

FS or trade lathe threading stop (ID help?)

Andy St

Stainless
Joined
Oct 9, 2005
Location
Pittsburgh, PA
For sale or trade a lathe threading stop. Seems to be in good condition original paint is almost all gone. I have no idea what lathe this fits. Hole for the stud / bolt is 7/16 and is ~1/2" on center from the top of the dovetail.
If anyone can ID it that would be great.
$20 + shipping

Andy011.jpg012.jpg
 
OK, what I need it to fit is 3-3/4 wide at the outside of the dovetail, 2.75 in the valley and 4-1/4" across two 1/2" dowel pins.

If that will fit, I'll take it.

This would be for the vertical column on a P&W mill, but that's not an original one for it.

Steve
 
SteveM
Just a rough measurement it looks like about 4 3/8 would be the smallest at the widest part without modification.

Let me know

Thanks

Andy
 
FWIW, threading stops aren't really too hard to make.

Yes, I just haven't gotten it up to the top of my list.

This is for the P&W mill, and the adjustment screw needs to be offset to the side. There was one on ebay that went for cheap, but I didn't see it until it was too late. The seller didn't know what it was for.

Steve
 








 
Back
Top