New to this so if not ok....
8-Station Tool Turret. Uses gang-style tooling with 1/2" centers. Was bought new in 2017 on a TL 2 lathe and only used for a short time (about a couple of weeks) and hasn't been used since. Was changed out for a 4 post due to job requirements. Was an easy change out. Unbolted from slide table, unplugged 3 wires, 2 air lines, and changed the setting from 8 position to 4 position on the controller.
Was an $8200 option from Haas.
Please email [email protected] for further details.
8-Station Tool Turret. Uses gang-style tooling with 1/2" centers. Was bought new in 2017 on a TL 2 lathe and only used for a short time (about a couple of weeks) and hasn't been used since. Was changed out for a 4 post due to job requirements. Was an easy change out. Unbolted from slide table, unplugged 3 wires, 2 air lines, and changed the setting from 8 position to 4 position on the controller.
Was an $8200 option from Haas.
Please email [email protected] for further details.