Putting a bunch of different categories in one add so I can keep track better
All of the lathe workholding was bought for the ST10. I ASSume its the same for other models. But I have never tried it on others.
Most has been used a few still unused.
(3) 1.25 bore
(3) 1.0 Bore
(1) .750 Face holder
(13) Stick holder sets
(3) Coolant blocks
(3) bore size adapters.
New a little over $2000
$900 for all wont separate.
Mill lighting Bought new for a VM2. NIB
Had no idea I still had it until this move New $900
$400
Cat 40 holders. Still doing inventory All Kennametal
Will post pictures but I know there is a bunch of TG100 collet holders.
All are NIB
Waste of time here probably My Gunsmithing Jet 1340 Manual lathe
I might post pics of that when cleaned up
All of the lathe workholding was bought for the ST10. I ASSume its the same for other models. But I have never tried it on others.
Most has been used a few still unused.
(3) 1.25 bore
(3) 1.0 Bore
(1) .750 Face holder
(13) Stick holder sets
(3) Coolant blocks
(3) bore size adapters.
New a little over $2000
$900 for all wont separate.
Mill lighting Bought new for a VM2. NIB
Had no idea I still had it until this move New $900
$400
Cat 40 holders. Still doing inventory All Kennametal
Will post pictures but I know there is a bunch of TG100 collet holders.
All are NIB
Waste of time here probably My Gunsmithing Jet 1340 Manual lathe
I might post pics of that when cleaned up