benha
Plastic
- Joined
- Aug 14, 2012
- Location
- San Francisco, CA
Hello,
I've got 4 sets of:
- K10 Pneumatic ZPS Surface Mounted Clamping Modules
- K10 Clamping Brackets for Surface Modules
- K10 Pull Studs
- K10 ZPS Engagement Screw
MSRP on this stuff is:
Module $1685.00 ea
Bracket $334.75 ea
Stud $67.98 ea
Screw $21.63 ea
So each set would list for $2109.36. I'm sure actual retail would be a bit less, but I'm not sure.
Anyway, these are very, very lightly used. The studs are still installed with a light press fit in some aluminum fixture plates and I haven't figured a good way to get them out. My preference would be to deliver them in the plate and let the buyer remove them, but I can give it a go if you insist.
This stuff was used as part of a workholding prototype process that didn't lead to a production system. They were never used in production and if I'm not mistaken they never actually got used for more than testing the concept. Other than a little surface rust on the mounting brackets it all looks like it just came out of the box.
My preference is to sell the whole shootin' match to a single buyer - I'm asking $6750 obo - but I'll consider splitting it up for the right deal.
Thanks,
-Ben
I've got 4 sets of:
- K10 Pneumatic ZPS Surface Mounted Clamping Modules
- K10 Clamping Brackets for Surface Modules
- K10 Pull Studs
- K10 ZPS Engagement Screw
MSRP on this stuff is:
Module $1685.00 ea
Bracket $334.75 ea
Stud $67.98 ea
Screw $21.63 ea
So each set would list for $2109.36. I'm sure actual retail would be a bit less, but I'm not sure.
Anyway, these are very, very lightly used. The studs are still installed with a light press fit in some aluminum fixture plates and I haven't figured a good way to get them out. My preference would be to deliver them in the plate and let the buyer remove them, but I can give it a go if you insist.
This stuff was used as part of a workholding prototype process that didn't lead to a production system. They were never used in production and if I'm not mistaken they never actually got used for more than testing the concept. Other than a little surface rust on the mounting brackets it all looks like it just came out of the box.
My preference is to sell the whole shootin' match to a single buyer - I'm asking $6750 obo - but I'll consider splitting it up for the right deal.
Thanks,
-Ben