Thread: Monarch C part out

If this is a 16C (18 1/2" swing) i could use the cast bracket that supports lead screw, drive rod and clutch rod on the tailstock end.

Mark

Originally Posted by marka12161

If this is a 16C (18 1/2" swing) i could use the cast bracket that supports lead screw, drive rod and clutch rod on the tailstock end.

Mark

Not a 16" it is 14", see pic of ID tag.

Originally Posted by Rob F.

Not a 16" it is 14", see pic of ID tag.

Gotcha, thanks

Originally Posted by marka12161

If this is a 16C (18 1/2" swing) i could use the cast bracket that supports lead screw, drive rod and clutch rod on the tailstock end.

Mark

I know that the swing is different, but I have that piece off, maybe we can compare dimensions?

Sent from my SM-N960U using Tapatalk

Taper attachment pulled. That was nasty.

It will obviously need taken apart and cleaned up.

Sent from my SM-N960U using Tapatalk

3 jaw chuck off as well. Its a Bison.



Sent from my SM-N960U using Tapatalk

Originally Posted by Mr.Green

Taper attachment pulled. That was nasty.

It will obviously need taken apart and cleaned up.

Sent from my SM-N960U using Tapatalk

Not gonna be a bolt on for my machine so count me out on the taper attachment.

how much for taper attachment and all parts shown with it?

Did the apron gears come apart like in post 4 of this other thread on a cy?
It kind of looks like the gear for the bed rack is cut on the end of the shaft, with the nut on the front?

Monarch 16CY Apron Removal and Cleaning

Originally Posted by DocsMachine

-Thanks CB. It'll need to be a fairly big one to fit the Springfield. I bought one from another PM'er not long ago, but the tooth count is wrong- I'd have to cut a new gear and restamp the face to use it.

Which I'll do if I have to, neither is that complex an operation, but if i can find one that's a little more plug-and-play, that might be preferable.

Doc.

Well, the one I have won't work either. It's for 2 TPI leadscrew. It's also been busted and re-brazed, and is locked up.

Originally Posted by DocsMachine

I could use a good steady for an 18" actual-swing machine, if you have one...

Doc.

I didn't get a chance to go through and measure the steadies. Dad said he did so and made a list, but IDK if I trust his numbers entirely. I might have that info by this weekend.

A two TPI leadscrew? Holy crap. What was the machine for, cutting corkscrews?

But I appreciate your looking. As I said, I have one I'd bought here earlier, I'll just have to cut a new gear and re-stamp the dial face.

No rush on the steadies, whenever you have the chance.

Doc.

Sending pm regarding taper attachment.

Originally Posted by Mr.Green

I know that the swing is different, but I have that piece off, maybe we can compare dimensions?

Sent from my SM-N960U using Tapatalk

Sorry,

Haven't checked this thread lately due to difference in swing. Yes, we can check dimensions. Let me take some measurements this evening.

Thanks
M