sirAIG
Aluminum
- Joined
- Jan 10, 2019
- Location
- State College
I have tooling laying around from my old bridgeport explorer. I am 99% sure these are NMTB30. Most have seen quite a bit of use over the years, but still hold cutters and make chips. I made a lot of money off these holders and was able to purchase into a new machine.
Have no idea of value, some stuff is pretty beat up, but still good for a garage warrior.I just dont want to throw the stuff away. Would prefer to sell as the NMTB as a package. Located in Pennsylvania, will ship at buyers expense.
List of collets/holders.
NMTB 30 - holders
Endmill holders:
.375"
.500"
.750"
1.00"
Collet Holders:
6 known "good" holders
1 marked "bad" with sharpie, I never even inspected to see what was "bad" from previous owner. Will include wrench and ugly tool for holding holders to tighten.
Collets for above holders:
1/8"
3/16" (x2)
1/4" (x2)
5/16"
11/32"
3/8" (x4)
7/16" (x2)
1/2" (x2)
5/8" (x3)
FaceMill Holders:
.750" shank
1.00" shank (missing original bolt)
Drill chucks/holders:
2x holders/jacobs chucks
1x jt33 taper holder without chuck
Have no idea of value, some stuff is pretty beat up, but still good for a garage warrior.I just dont want to throw the stuff away. Would prefer to sell as the NMTB as a package. Located in Pennsylvania, will ship at buyers expense.
List of collets/holders.
NMTB 30 - holders
Endmill holders:
.375"
.500"
.750"
1.00"
Collet Holders:
6 known "good" holders
1 marked "bad" with sharpie, I never even inspected to see what was "bad" from previous owner. Will include wrench and ugly tool for holding holders to tighten.
Collets for above holders:
1/8"
3/16" (x2)
1/4" (x2)
5/16"
11/32"
3/8" (x4)
7/16" (x2)
1/2" (x2)
5/8" (x3)
FaceMill Holders:
.750" shank
1.00" shank (missing original bolt)
Drill chucks/holders:
2x holders/jacobs chucks
1x jt33 taper holder without chuck