Firstly I'd like to say hello to everyone as this is my first post.
I bought a Pacific FTV4 (Lagun) last week with a lot of new tooling but unfortunately every arbor has a 5/8" draw bar thread where the mill has an M16 draw bar. I've already made a 5/8" draw bar to suit but changing them is a nightmare if going between metric & imperial. Those with an Nt40 equipped Lagun will understand.
So what I need is an NT40 collet chuck with a 5/8" draw bar thread to suit ER40 collets. I don't need the collets just the chuck.
TIA, Peter.
I bought a Pacific FTV4 (Lagun) last week with a lot of new tooling but unfortunately every arbor has a 5/8" draw bar thread where the mill has an M16 draw bar. I've already made a 5/8" draw bar to suit but changing them is a nightmare if going between metric & imperial. Those with an Nt40 equipped Lagun will understand.
So what I need is an NT40 collet chuck with a 5/8" draw bar thread to suit ER40 collets. I don't need the collets just the chuck.
TIA, Peter.