What's new
What's new

Possible face milling extension for a horizontal boring mill, maybe

mattthemuppet

Stainless
Joined
Apr 22, 2016
Location
San Antonio
Not a very descriptive title, but I don't have a clue what this fits or even what it's for. Hopefully the pictures and dimensions will help:
IMG_20211124_183249.jpg
IMG_20211128_140601.jpg
IMG_20211129_142405.jpg

base is 250mm(9.93") by 170mm(6.68") by 35mm(1.4") high with 4x M20x2.5 bolts on 70mm center to center spacing. Key is 20mm(0.79") wide by 10.5mm(0.42") high. Center hold is threaded M30x3.5 (finally a use for that tap!).

column is 134mm(5.29") diameter by 312mm (12 1/2"?) tall from the top of the base.

End has an 80mm(3.15") hole, ~145mm(5.73") deep with a stretch of either 1.5mm(my guess) or 16tpi thread down in there. I can get better measurements if needed. Loads of coolant supply holes all over the place. There are 4x threaded holes ~11mm from the edge, so ~51mm center to center of bore. They're either 3/8-24, which kinda threads in, or M10x1 which I can't test (don't have a bolt or tap of that pitch). My guess would be metric as the rest of the measurements seem to line up with metric.

Weight is 90lb on the dot, plus whatever weight crating it adds.

$50 plus shipping from 78254. UPS ground might be an option, or the Fastenal store to store service.

Let me know if you need any more pictures/ measurements to make sure it is what you think it is. This thing's doing a great job holding down my floor, but I'm going to get pretty tired (literally) shuffling this thing around :)
 








 
Back
Top