Rockwell 82-950 3/4hp sngl ph motor

Sorry, as soon as I posted I realized no indication in title whether it was FS FT WTB, and no editing of title

This offer is for PM members with 100+ posts, you get this for free,you pay freight

Rockwell 82-950 3/4hp sngl ph, 115/230v,1725rpm, motor with 3/4" shafts
Pulled working from a Delta Rockwell 17" drill press
I converted the drill press to 3 ph

For someone wanting to "restore" to original this would be nice, it was most likely used on a variety of their machines.
Under capped end is a 2nd shaft
The wire leads show insulation cracking and will need to be traced back and repaired/replaced but the motor was running fine when pulled.

I'll work with someone to crate and ship it.
Motor by itself is about 50lbs (cast iron end bells)add another 50lbs for a real crate

Repeat
This offer is for PM members with 100+ posts, you get this for free,you pay freight

I suggest getting a quote from Fastenal from store at zip 19804, Germay drive

Mike

If I needed a motor, I'd get in the car and drive down to get that.

Nice of you to offer it up.

Steve

2+ years since I posted this and this morning, still tripping over it.
Last try and then Friday the scrap man can have it
Still free for the shipping, and I'll still work with someone on that

I think this would fit my old South Bend 10L nicely. But do you have any other suggestions for shipping? Fastenal is not doing cross-country freight at the moment. Fedex and UPS are a couple hundred bucks, prohibitive for an old motor. And I don't think USPS will go over 70lbs.

I'd like to have that motor, but I don't believe I have the required # of posts.

Didn't know Fastenal was down for cross country

I'll loo into some other options Wednesday

PM's sent to jwearing & sparky45 re shipping the motor by Fast all

nothing outstanding about those old motors. unless you just have to have that frame, and are within driving distance...

i could understand restoring a vintage rockwell machine with
the correct motor.

newer, more efficient motors are cheap as hell. $40-50 bucks
at the flea market or craigslist. you might need a new $10 run
cap and a $10 pair of 6205 bearings . old 1-phase motors might need an unavailable centrifugal switch... . just saying

unless you're buying from amazon, freight costs are insane.

good luck.