Wanted: Brass / Bronze 3.5" round bar / tube (Drops?)

ecosta said:

I was asked to do a small job for a family friend. They require essentially a bushing and they asked that it be brass or bronze, or if necessary stainless.

I've poked around on ebay but not much luck. To buy new is a little expensive. So I was curious if anyone had any drops they'd like to get rid of. The specs are as follows:

Can be solid bar, but tubing / hollow bar would be best.

Min 3.375" OD
Max 3" ID
Min 2.75" long

Thanks!
Eric

Click to expand...

Mr_CNC_guy said:

I have some bronze that would fit. It is bar stock that
your piece could be cut from. I am in NH just off Rt. 93
so you could save on shipping.

Click to expand...

tft1987 said:

This fits your requirements, and is not that costly... McMaster-Carr

Click to expand...

tft1987 said:

This fits your requirements, and is not that costly... McMaster-Carr

Click to expand...

Dualkit said:

That stuff is nasty. Look at the tolerances. Why would anyone use bronze if they could use brass?

Click to expand...