blackbeard
Plastic
- Joined
- May 15, 2016
Restoring two Van Norman 944 Boring Bars
Looking for the following:
- anything that is related to clamping the machines to the block (in cylinder anchors, clamp foot, t bar, bridge, etc.)
- lapping discs (not import, original if you have them)
- crank arm, handle shaft, clutch, gear and bushing for raising and lowering boring bar into cylinder.
- milling heads that screw into the boring bar from the bottom
- any additional parts for spares or parts machines would be helpful.
These machines are in pretty good shape but someone has been pretty rough on one of them. Both spin and operate, move up down, etc.
Thanks for any help/parts you can provide.
Scott
Looking for the following:
- anything that is related to clamping the machines to the block (in cylinder anchors, clamp foot, t bar, bridge, etc.)
- lapping discs (not import, original if you have them)
- crank arm, handle shaft, clutch, gear and bushing for raising and lowering boring bar into cylinder.
- milling heads that screw into the boring bar from the bottom
- any additional parts for spares or parts machines would be helpful.
These machines are in pretty good shape but someone has been pretty rough on one of them. Both spin and operate, move up down, etc.
Thanks for any help/parts you can provide.
Scott