WTS/WTT: 2J lathe collets

Various used 2J lathe collets for sale or trade (for any 2J collet sizes I need). Here's what I have:

Lot of 19 2J collets. This is almost a full set from 3/16" to 1-3/8" by 16ths, except that no 5/16" collet is included. Good condition overall, but some have minor damage that shouldn't affect use. All are Hardinge except the 1-3/8" collet, which was made by Balas. $375.

Hardinge metric 6mm 2J collet. $40.

Various 2J collets in good condition. Various brands. 1/4" (qty 1), 7/16", 33/64", 11/16", 3/4" (qty 2), 13/16", 15/16" (qty 3), 1-1/8" (qty 3), 1-1/4", 1-3/8". $15 each.

Various 2J collets in fair condition. Various brands, some unreadable. All have more damage or wear than the "good" condition collets above. 13/32", 9/16", 3/4" (qty 2), 13/16" (qty 2), 7/8" (qty 2), 15/16" (qty 3), 1" (qty 2), 1-5/16". $12 each.

I can provide more photos on request. Note that the list of collets above should be correct, but the photos may show more than are available as some get sold.

None of the prices above include shipping, but I will combine shipping and only charge actual cost.

"(I don't recognize the emblem, but it has a large "B" as part of it)"

Probably Balas if the mark is a big B and a Co.

https://www.ebay.com/itm/120393436328

Larry

L Vanice said:

"(I don't recognize the emblem, but it has a large "B" as part of it)"

Probably Balas if the mark is a big B and a Co.

https://www.ebay.com/itm/120393436328

Larry

Click to expand...

Thanks a lot!

paroikoi said:

Various used 2J lathe collets for sale or trade (for any 2J collet sizes I need).

Click to expand...

What sizes do you need? Which of your extra 2J collets are Hardinge?

rimcanyon said:

What sizes do you need? Which of your extra 2J collets are Hardinge?

Click to expand...

Sizes I need are:
Any hex, square, or oversize
14mm or any whole-number metric below 6mm or above 20mm
1/16"
Any 32nd except 5, 9, 13, 15 or 19
Any 64th except 15, 17, 25, 33, 49, 1-9/64 or 1-17/64

Of the collets I offered for sale or trade above, the following are Hardinge:
6mm
The whole "almost complete" set by 16ths except for the 1-3/8
The "fair" collets: 13/32, 9/16, 3/4, 7/8 (qty 2), 13/16 (qty 2), 15/16 (qty 2), 1, 1-5/16
The "good" collets: 7/16, 33/64, 11/16, 3/4, 13/16, 15/16 (qty 3), 1-1/8 (qty 3)


If a potential trade was in work, I suppose I could also use a 5/16 to make the set by 16ths above more complete...