
Results 1 to 2 of 2
Thread: FV1365 Tool change program
-
11-08-2016, 02:27 PM #1
FV1365 Tool change program
I cannot for the life of me find the tool change program on this machine with the Fanuc 0i-MD controller.
So far I've changed 3202 NE9 and PSR to allow for searching and editing of the 9xxx programs but still no luck. I have made and edited a 9xxx program but that is the only one that will show up in the directory. I've also seen reference to parameter 10 bit 4 but this controller does not have that bit labeled as mentioned in a few other threads on here have suggested.
I vaguely remember a former maintenance tech say that the tool change was done through the ladder only without its own program.
Have any of you run into this before?
-Alex
-
-
11-24-2016, 12:12 PM #2
Are you trying to get the machine not to travel g28 x0 y0. Before the tool change? I have a fv1050s and would suggest you call toyoda and ask for Jim gibbler he's toyoda main vmc tech
Bookmarks