roll-a-leblond
Cast Iron
- Joined
- Jan 18, 2014
- Location
- louisiana
Hey gang,I have a cincy 9" column 4' arm radial drill I'm putting a vfd on. I have a twin drill I set up with one a couple months ago, no problems.
This one however only has 3 wires coming out of the motor instead of the usual 9 for 3 phase. I think it was set up for 440v,I went in there to rewire it for 220v and saw only 3 wires. How do I check to see what voltage its wires up for?
This one however only has 3 wires coming out of the motor instead of the usual 9 for 3 phase. I think it was set up for 440v,I went in there to rewire it for 220v and saw only 3 wires. How do I check to see what voltage its wires up for?