Here are some better quality photos, I can't zoom in or the text becomes blurry. The motor can't be anymore than a 2 HP motor, it is a right angle motor that drives the 4 acme screws that lift the table on the four corners. I have seen the motor in the past but never took down the specs. I run the machine at 230V, but it can be run at 480V if tapped properly.
How many terminals does it have? And how are they marked? 10 total terminals / Marked:SRUV 6 unmarked(however there is a missing sticker)
Does it fit though a hole in a panel or something, and get held on by a nut? Mounts to the back of a panel, held in with 4 bolts
What size is the shaft for the knob? 6mm hex shaft (the control knob had to be destroyed to remove the switch, a new one will be made)
What are the specs on the motor that it controls? I do not have the specs, I can't even get to the motor as I can't raise the table for access
How many wires were attached to the switch? 6 wire connection, at SRUV and two unidentified poles
Is it a momentary or a maintained switch? Momentary
How large is the switch body? 56mm body