Right so I have 3 phase in the workshop in a Inconvenient location, boss doesn’t want move it to the other side ; so I have got us a phase converter (transwave 5hp)
Plugged in Harrison m300 lathe
Works fine but dro flashed a blew a cloud of smoke - dead
How did this happen dro was fine before I ran lathe on a phase converter ?
The phase converter is set to 400v
And is wired correctly
Plugged in Harrison m300 lathe
Works fine but dro flashed a blew a cloud of smoke - dead
How did this happen dro was fine before I ran lathe on a phase converter ?
The phase converter is set to 400v
And is wired correctly