Mr.Green
Cast Iron
- Joined
- Apr 20, 2011
- Location
- NE Indiana
Have a 3hp direct drive motor that is running about half speed 1750 vs. 3500 judge by ear and the high amp draw, 25 amps continuous.
9 lead motor, I added onto the leads, left original numbers intact, paired leads (Y connected motor, 3, 2, 2, 2)
Rang it out, leads matched up.
Rotated 7,8,9 rang out again, which changes other pairs, still half speed.
Rotated again, same results.
Trying to avoid motor shop since I have to take entire machine, not pulling stator again unless at gun point.
What could be going on?
Sent from my SM-N960U using Tapatalk
9 lead motor, I added onto the leads, left original numbers intact, paired leads (Y connected motor, 3, 2, 2, 2)
Rang it out, leads matched up.
Rotated 7,8,9 rang out again, which changes other pairs, still half speed.
Rotated again, same results.
Trying to avoid motor shop since I have to take entire machine, not pulling stator again unless at gun point.
What could be going on?
Sent from my SM-N960U using Tapatalk