jappietoutou
Aluminum
- Joined
- Dec 2, 2015
- Location
- Montreal
hello
So I've posted a video of my RPC ( not here ), and I get some comments like : your system is way too complex, you should have used a Drive and a transfo instead , at half the cost......
I have a very basic, regular, unusual RPC, the same as most of you guys build here ! I took the plans here !! except for the voltage, from 240v to 575v , i'm in Canada and most industrial machine are on 575v/600c. but that is not the point. It works really well, I have a pony motor for starting. 7.5 hp Idler, take approx 18 amp on the 240v side.
So my question, what can I answer back to people questioning the RPC way ? I'm kind of frustrated.....
Jean-Pierre
So I've posted a video of my RPC ( not here ), and I get some comments like : your system is way too complex, you should have used a Drive and a transfo instead , at half the cost......
I have a very basic, regular, unusual RPC, the same as most of you guys build here ! I took the plans here !! except for the voltage, from 240v to 575v , i'm in Canada and most industrial machine are on 575v/600c. but that is not the point. It works really well, I have a pony motor for starting. 7.5 hp Idler, take approx 18 amp on the 240v side.
So my question, what can I answer back to people questioning the RPC way ? I'm kind of frustrated.....
Jean-Pierre