weedy64
Aluminum
- Joined
- Dec 12, 2005
- Location
- Langley, B.C.
I'm going to run a 20hp RPC with 235vac for most shop tools except a couple that need 575/600 V
I planned to feed a 600 x 208/120 15kva transformer that I possess...but it looks to me that I can only tap down 5% which will result in about 649v with a 236v lowside....crap!
Any suggestions without spending lots?
Thx
Another question, which 20hp motor
#1 9w 220/440 full end bells vents on the bottom old style Century
#2 12w 230/460 Toshiba WES vented on ends. Can wire Y or D
Which makes a better RPC Y or D and why so.
I planned to feed a 600 x 208/120 15kva transformer that I possess...but it looks to me that I can only tap down 5% which will result in about 649v with a 236v lowside....crap!
Any suggestions without spending lots?
Thx
Another question, which 20hp motor
#1 9w 220/440 full end bells vents on the bottom old style Century
#2 12w 230/460 Toshiba WES vented on ends. Can wire Y or D
Which makes a better RPC Y or D and why so.