NRDock
Cast Iron
- Joined
- Jan 24, 2015
- Location
- Central Pennsylvania
I've hooked up a 2 HP TECO E510 to the 1 Hp 1200 RPM motor on my Fray mill, but can't get the parameters right. It turns the spindle a few times before throwing a "CF08" Code. I've raised the PMSLV current from 50 to 100, and I've raised the PMSLV acceleration from 1 to 2. No change. I think I've performed the Auto tune. No Change.
I'm tired and don't understand everything I've tried. At the moment, I'm fixated on a minor annoyance: Whenever I change a parameter, the only way to get back to a point where I can attempt a start is to power down and back up again. There has to be a better way, but I haven't found it yet.
Any advice is welcome.
OK, I've calmed down and got that last part figured out now. At least I can sleep.
I'm tired and don't understand everything I've tried. At the moment, I'm fixated on a minor annoyance: Whenever I change a parameter, the only way to get back to a point where I can attempt a start is to power down and back up again. There has to be a better way, but I haven't found it yet.
Any advice is welcome.
OK, I've calmed down and got that last part figured out now. At least I can sleep.