Paul Cataldo
Stainless
- Joined
- Dec 9, 2004
- Location
- Atlanta, GA
Newly acquired Miller CP300 MIG setup
After reading a bit, I'm still unclear as to whether I would be better off using the Haas Kamp 1ph conversion, OR if I should run this welder on my 20hp RPC. I know guys have successfully used both methods, but I'm just not sure which method would (possibly?) produce the better arc? Or if there would be any loss of machine power/efficiency with one method vs the other?
Any advise would be much appreciated here guys.
After reading a bit, I'm still unclear as to whether I would be better off using the Haas Kamp 1ph conversion, OR if I should run this welder on my 20hp RPC. I know guys have successfully used both methods, but I'm just not sure which method would (possibly?) produce the better arc? Or if there would be any loss of machine power/efficiency with one method vs the other?
Any advise would be much appreciated here guys.