Chaval AlHazman
Plastic
- Joined
- Sep 26, 2020
Hi, My Maka Mortiser is having trouble with its automatic feed- advance of Motor head (the motor head sits on the table and advances into the workload creating a mortise with its oscillating chisel)
I believe that this is due to a low oil issue. Basically, it has a high pressure oil reservoir underneath the table that has tubes running into the table which controls the feed. I don't fully understand how it all works, but I'll attach the diagram from the manual (which is written in German).
I'm trying to figure out how to pump this thing with oil through the fitting shown. I don't know what type of pump is suitable and the proper fittings...
Does anyone any experience with this or something similar? the photos attached are tilted 90 degrees to the right- can't get them standing
I believe that this is due to a low oil issue. Basically, it has a high pressure oil reservoir underneath the table that has tubes running into the table which controls the feed. I don't fully understand how it all works, but I'll attach the diagram from the manual (which is written in German).
I'm trying to figure out how to pump this thing with oil through the fitting shown. I don't know what type of pump is suitable and the proper fittings...
Does anyone any experience with this or something similar? the photos attached are tilted 90 degrees to the right- can't get them standing
Attachments
Last edited: