macgyver
Stainless
- Joined
- Aug 2, 2012
- Location
- Pittsburg, KS
I was going though some files and saw these again, figured I would post a few up here and do a little show and tell.
This first one is a short run I did for a customer, I machined all the wood and aluminum, he did the concrete work. There were a couple Walnut tops and a Maple top.
The tops started out as a big thick blank and it was a flip operation. I did the bottoms first and then flipped them onto an mating vac fixture to do the top. THe aluminum connecting hardware was machined on the router as well. He did all the design and I just machined it. THe legs on the maple bench are cast, I did not do them.
This first one is a short run I did for a customer, I machined all the wood and aluminum, he did the concrete work. There were a couple Walnut tops and a Maple top.
The tops started out as a big thick blank and it was a flip operation. I did the bottoms first and then flipped them onto an mating vac fixture to do the top. THe aluminum connecting hardware was machined on the router as well. He did all the design and I just machined it. THe legs on the maple bench are cast, I did not do them.